STAGE AND STUDIO MODES

You can make AMPX as complex - or as simple - as you like! Want to create your sounds and then focus fully on your playing onstage? Then use AMPX in Stage Mode! In this mode, you keep the flap closed. Then Bass, Middle, Treble and Presence controls act as a post EQ - and thus act as a Master EQ on all presets. This means you can adjust all of your pre-created presets in a second. On the lower control panel in Stage Mode, you also have access to the Master Volume as well as your favorite amps assigned to  CLEAN, VINTAGE, CLASSIC, MODERN, gain and volume for the active amp, and ON/OFF controls for the selected boost, drive, modulation, delay and reverb pedals. 

If you want more control, open the flap and engage Studio Mode! This gives you access to AMPX’s second control panel, where you can program each of your sounds and presets to your heart’s content. Note that when you’re in Studio Mode, the tone control knobs correspond to those of the selected amp. Here, the tone control is a central component of each individual amplifier, and it is modelled on the original amp.

Foot switches

AMPX also has a freely assignable footswitch concept, which allows you to save and recall up to two presets per switch, and freely assign switching (e.g. pedal On/Off switches) and control functions. If you need more switches, you can do this by using a BluGuitar REMOTE or an external MIDI controller, and these will also be part of your programmable rig.

Presets

The first preset (blue) is activated with the first hit on a footswitch. If you hit that footswitch again, you will access the second preset on the same footswich. Hitting the same footswitch again, you recall the second preset (purple).

Custom functions

Put our most important functions such as solo volume, your favorite boost pedal or any kind of function to any of the foot switches.