If you want to activate or deactivate pre-effects and effects in the FX loop of the AMP1 at the same time, you can do this with the help of the REMOTE1 and the Looper Kit by storing the respective switching states in a preset.

With the help of REMOTE1, you can determine for each preset for the FX loop of the AMP1, as well as for each of the 4 loops of the Looper Kit, whether they should be switched ON or OFF.

Suppose you want to activate FX pedal 1, which should be in front of AMP1, and effects pedal 2, which is in the FX loop of AMP1, at the same time. Please proceed as follows:

• Connect the REMOTE1, including the Looper Kit, to the AMP1.
• Place the Looper Kit in front of the AMP1 (tip: How to wire the Looper Kit correctly‍).
• Switch FX pedal 1 to one of the four loops in the looper kit, for example to loop 1.
• Place FX pedal 2 in the AMP1's FX loop.
• Turn on all of the FX pedals that are to be used.
• When saving a preset with REMOTE1, specify that both the FX loop of the AMP1 and loop 1 of the Looper Kit are set to ON.